Lubbock · Wolfforth · Shallowater · Slaton
Plumbing Problems in Lubbock, TX: Know What You’re Dealing With Before Anyone Starts Work
Water heaters, slab leaks, drains and sewer lines: find the zone, do the one safe thing first, see what the work usually costs, and learn how to check a plumber’s license with the State of Texas. Quote requests open soon; matching with an independent local plumber will be free.
Where is the water? Start with the zone
Pick the part of the house the problem is in. Each zone lists what to look for, the one safe thing to do first, and when to stop and get a licensed plumber.
-
Water heater
Garage, utility closet or attic- Signs
- No hot water or it runs out fast, rust-coloured hot water, popping or rumbling, water pooling under the tank.
- Do this first
- Smell gas? Leave first, then call the gas utility or 911 from outside. Otherwise, close the cold-water valve on top of the tank; electric units: breaker off if you can reach the panel without standing in water; gas units: control to OFF.
- Stop and call when
- The relief valve keeps discharging, or water is near the burner or wiring. Stay clear and get a plumber.
-
Under the slab
Pipes below a concrete floor- Signs
- A warm or damp spot on the floor, the sound of running water with every tap off, a water bill that jumps for no reason.
- Do this first
- Turn every fixture off and watch the meter’s leak indicator for ten minutes. If it moves, write the reading down.
- Stop and call when
- The floor is wet or warm and spreading. Close the main shutoff and get a leak-detection visit before anyone breaks concrete.
-
Drains
Sinks, tubs, showers, disposal- Signs
- One slow fixture, gurgling, a disposal that hums but won’t turn, a sink that refills from below.
- Do this first
- One fixture only: a plunger or a plastic drain snake. Disposal: switch it off and never reach into it; try the reset button under the unit.
- Stop and call when
- Two or more fixtures back up at once, or water comes up in a tub when a toilet flushes. That points to the main line.
-
Sewer line
House to the street, under the yard- Signs
- Several drains slow together, sewage smell outside, a soggy patch in the yard, backups in the lowest drain.
- Do this first
- Stop running water and the washer. Find the cleanout cap so a contractor can reach the line.
- Stop and call when
- Sewage is in the house. Keep people and pets away and stop using water until the line is cleared.
-
Water line & softener
Meter, main shutoff, softener loop- Signs
- White crust on fixtures and glass, low pressure at every tap, spots on dishes, a softener that keeps using salt.
- Do this first
- Find and label your main shutoff now, before you need it. Clean one aerator to see if the pressure comes back.
- Stop and call when
- Water is coming up in the yard between the meter and the house, or pressure drops to nothing.
-
Outside & freeze points
Hose bibs, exterior walls, attic runs- Signs
- A hose bib that drips or won’t shut, no water after a hard freeze, a wet exterior wall.
- Do this first
- Before a freeze: disconnect hoses, cover the bibs. After one: open a tap and leave the main ready to close if a pipe thaws and splits.
- Stop and call when
- You find a split pipe or water inside a wall. Close the main and keep it closed until the line is repaired.
Before anyone starts work
- Ask for the plumber’s Texas license number and look it up with the State plumbing board.
- Get the trip or diagnostic fee and the repair price in writing before work starts, including any after-hours charge.
- Know where your main shutoff is. Closing it stops most leaks from getting worse while you wait.
- Prices with a source Every range names where it came from and when it was checked.
- Rules from the agency itself Permit and license facts are read from the City of Lubbock and the State plumbing board, not from blogs.
- License check before you hire How to look up a plumber with the Texas State Board of Plumbing Examiners.
- Free matching No cost and no obligation. Quote requests open soon.
How matching works
- Step 1 Tell us where the problem is Water heater, slab, drain, sewer or water line, plus your ZIP code and whether you own the home.
- Step 2 We pass it to one local plumber An independent Lubbock-area plumbing contractor who covers your area gets your request.
- Step 3 They quote the work The plumber contacts you, looks at the problem and prices it. You decide, and for a big job you can get other quotes too.
Quote requests open soon. Serving Lubbock, Wolfforth, Shallowater, Slaton and the rest of the Lubbock area. How matching works · Service area
Questions Lubbock homeowners ask
Who licenses plumbers in Texas?
Plumbers in Texas are licensed by the Texas State Board of Plumbing Examiners, not by the Texas Department of Licensing and Regulation. Before you hire anyone, ask for the plumber’s license number and look it up with the Board. The Board’s free public license search lets you look a plumber up by license number, name, city or county; our license-check guide walks through it step by step.
How can I tell if I have a slab leak?
Turn off every faucet, shower and toilet fill, the ice maker, dishwasher, washer, softener and sprinklers, then watch the leak indicator on your water meter for ten minutes. If it moves with nothing running, water is going somewhere. A warm or damp patch on the floor or the sound of running water points under the slab. Ask a leak-detection visit what it includes before anyone breaks concrete; our slab leak guide has the full meter test.
How does matching work, and what does it cost me?
Nothing. Once quote requests open, you tell us what is going on and where you are, and we pass it to an independent local plumbing contractor who covers your area. They contact you, look at the problem and quote the work. Lubbock Plumbing Experts is a referral service: we do not do plumbing work and we are not a licensed plumber.